Walk-In Shower Installation in Bethesda, MD
We install seamless, grout-free acrylic walk-in showers with a rigid custom base, glass doors and an anti-slip surface.
Walk-In Shower Installation for Bethesda Homes
In the larger Bethesda homes toward Kenwood, Sumner and Burning Tree, the walk-in shower project is usually an upgrade of an existing one. The primary bath has a tiled stall from an earlier renovation — a framed door, a mud-set pan that's started to leak, grout that's darkening — and the request is a bigger, cleaner, more open shower.
We remove the old stall down to the studs, check the pan framing and subfloor for the water damage a leaking tile pan tends to leave, and install a rigid custom-measured acrylic base with a seamless grout-free surround. Because these are generous primary baths, there's room to enlarge the shower: a frameless glass panel, a rain head with a hand-held wand, a bench, and a recessed niche.
Finish is the priority here. We coordinate the acrylic pattern with the room's stone or tile, match the hardware to the existing fixtures, and keep the glass detailing clean. Bethesda also has a lot of whole-house rebuilds — if the bathroom is part of a larger project, we'll work to your designer's spec.
Your free in-home consultation covers exact measurements, a 3D preview and a price locked in for 12 months. Bethesda is one of the eastern Montgomery County areas we serve from Howard County.
What We See in Bethesda Bathrooms
Bethesda runs from 1920s–1950s brick colonials and Capes close to downtown and in Edgemoor to large 1960s–80s houses and newer rebuilds farther out toward Kenwood and Burning Tree. The older close-in homes usually have original cast-iron tubs in small tiled bathrooms.
What It Costs in Bethesda
We don’t quote a price over the phone — every bathroom is different. You get an exact, locked-in figure at the free in-home consultation, valid for 12 months, with 0% interest financing options and no hidden fees.
How the Project Goes
1. Free in-home consultation
Exact digital measurements, a 3D design preview, and a locked-in quote valid for 12 months.
2. Custom-fitted components
Your acrylic base and surround are measured and pre-fitted to your bathroom before installation day.
3. Professional installation
A factory-trained local crew removes the old fixture, updates plumbing as needed, installs the new system and cleans up.
Permits in Montgomery County
Montgomery County requires a plumbing permit for a tub-to-shower conversion. We obtain it through the Montgomery County Department of Permitting Services and schedule the inspection — handled under the required licenses.
Walk-In Shower Installation in Bethesda — FAQs
Our Kenwood primary shower pan is leaking — can you replace just the shower?
Yes. We remove the tiled stall and pan, repair the subfloor and framing underneath, and install a watertight acrylic base and grout-free surround with a new frameless glass panel. The rest of the bathroom stays as-is.
Can the new shower be larger than the old one?
Usually. Bethesda primary baths often have room to extend the shower, especially if a small tub next to it also comes out. We measure at the consultation and show you the options.
Can you work to our architect or designer’s specifications?
Yes. On whole-house rebuilds and larger renovations we install to the designer’s spec — panel pattern, glass, hardware and layout — while keeping the grout-free acrylic system’s watertight base and surround.
Free In-Home Consultation
Step 1 of 3