Walk-In Shower Installation in Clarksville, MD
We install seamless, grout-free acrylic walk-in showers with a rigid custom base, glass doors and an anti-slip surface.
Walk-In Shower Installation for Clarksville Homes
Not every Clarksville shower project involves the garden tub. In the River Hill and Pointers Run homes built in the 1990s and early 2000s, the primary bathroom already has a separate shower — a builder-grade tiled stall with a framed door, a mud-set pan that has started to leak, and grout that has been sealed and scrubbed for twenty years. Replacing that shower is its own job, and it's one we do a lot of here.
We tear out the old stall down to the studs and subfloor, check the pan framing for the water damage that a slow-leaking tile pan almost always leaves, and install a rigid custom-measured acrylic base with a seamless grout-free surround. Because these are larger primary bathrooms, there's usually room to make the new shower bigger than the old one — a frameless glass panel, a rain head with a hand-held wand, a built-in bench and a recessed niche.
In the secondary and hall bathrooms of these Clarksville homes it's the opposite problem: a one-piece fiberglass shower or tub-shower that has yellowed and gone brittle. Same fix, smaller footprint. The acrylic wall panels come in tile- and stone-look patterns so the new shower ties into a bathroom you're not otherwise redoing.
Your free in-home consultation includes precise digital measurements, a 3D preview of the finished shower and a price locked in for 12 months. Our crews come from Columbia, about twelve minutes away.
What We See in Clarksville Bathrooms
Clarksville homes are mostly 1990s–2010s executive houses, many with a large primary bathroom built around a corner jetted or garden tub that rarely gets used.
What It Costs in Clarksville
We don’t quote a price over the phone — every bathroom is different. You get an exact, locked-in figure at the free in-home consultation, valid for 12 months, with 0% interest financing options and no hidden fees.
How the Project Goes
1. Free in-home consultation
Exact digital measurements, a 3D design preview, and a locked-in quote valid for 12 months.
2. Custom-fitted components
Your acrylic base and surround are measured and pre-fitted to your bathroom before installation day.
3. Professional installation
A factory-trained local crew removes the old fixture, updates plumbing as needed, installs the new system and cleans up.
Permits in Howard County
A like-for-like tub-to-shower conversion in Howard County involves plumbing work, so it generally needs a plumbing permit from the Howard County Department of Inspections, Licenses and Permits. We pull the permit under our MHIC license (#169443) and schedule the required inspection — it is not something the homeowner has to arrange.
Walk-In Shower Installation in Clarksville — FAQs
Our River Hill primary shower pan is leaking — can you replace just the shower?
Yes. We remove the old tiled stall and pan, inspect and repair the subfloor and framing underneath (a leaking mud-set pan usually causes some damage), and install a watertight acrylic base and grout-free surround with a new glass enclosure.
Can we make the new shower larger than the builder one?
Often yes. Primary bathrooms in Clarksville usually have room to extend the shower, especially if a small soaking tub next to it also comes out. We measure at the consultation and show you the options.
Do the acrylic walls really look like tile?
From normal viewing distance, yes — the stone- and subway-look panels read as tile but have no grout lines. Up close you can tell, but there's nothing to regrout or reseal and the surround wipes clean.
Free In-Home Consultation
Step 1 of 3